• Easily removed for cleaning
• Chequer plate finish with oval logo
• Will fit either left or right hand drive
• Raised edge border to keep in mud and grime
• The Series front floor mats are supplied in pairs
• Will NOT fit a Lightweight or a 6 cylinder type Series
• Can be cleaned with water and detergent do not use an abrasive brush
• Location points are marked on the mats for throttle stop and dip beam depending on the vehicle type these can be cleared if required

• For the second row passengers in a 109" county station wagon
• Easily removed for cleaning
• Will fit either left or right hand drive
• Will fit a 6 cylinder type Series II & III
• Raised edge border to keep in mud and grime
• The Series second row mats are supplied in pairs
• Chequer plate finish with lowered areas for seat mounting points
• Can be cleaned with water and detergent do not use an abrasive brush

• Auto-4 Rear Heavy Duty Floor Mat
• This mat is 36" x 47 3/4 " long and will fit the rear floor well only
• Chequer plate finish
• Easily removed for cleaning
• Will fit either left or right hand drive
• Will fit 90" & 110" County Station Wagon
• Raised edge border to keep in mud and grime
• The Series rear floor mat is supplied in one piece
• Non slip strips to ensure goods do not slide around in the back
• Will fit all models including Lightweight or a 6 cylinder type Series
• Can be cleaned with water and detergent do not use an abrasive brush

Series Acoustic Moulded Matting System (not V8, Lightwiegt or 6 Cylinder)

This is the only front matting system available that is approved by Land Rover and the Ministry of Defence. This is the Kit. Already fitted to most military Land Rovers and used in extreme environments, this kit has proved itself to be up to the job time and time again. Supplied as a 3 piece kit with the floor & tunnel in one piece with the seat box totally covered and the bulk head centre. Approved at Millbrook testing ground and reduces the noise and heat levels in the front to below required safety standards.